JAB DUC 2 250LTR HORIZONTAL
250LTR INDIRECT HORIZONTAL - suitable for indirect or direct installations
DIAM = 555MM
LENGTH = 1500MM (EXCLUDING EXPANSION VESSEL)
The Horizontal range is perfect for loft conversions, allowing more space but enough hot water for an extra bathroom.
• 25 Year Warranty
• Including One Year On Site Warranty
• U.K. Manufactured
All units supplied with the following:
INDIRECT
1 x Dual Stat. and High Limit Stat.
2 x3kw 240v s/p Immersion Heater
1 x Expansion Vessel
1 x T & P Relief Valve
1 x 3 bar Inlet Chain
1 x Two Port Motorised Valve
1 x pair of cradles
Cylinder information
The JAB D.U.C. is made from DUPLEX 2304 stainless steel giving the unit the strength for high pressure service but light enough for installation.
With a range including slim units and horizontal units it has never been easier to find the perfect location for installation.
COLD WATER SUPPLY
JAB DUC 2 Stainless unvented cylinders are capable
of delivering up to 55 litres of hot water per
minute given an adequate supply. The minimum
recommended supply is 20 litres per minute at
1.5 bar.
WHAT BOILER SHOULD I USE?
To ensure peak performance and efficiency
the cylinder should ideally be connected to an
oil-fired or gas condensing boiler. The primary
circuit must be pumped and can be open vented
or sealed. Energy requirement (BTU/KWH) will
vary according to cylinder volume.
LOCATION
Our stainless cylinders can be sited virtually
anywhere in the home, but consideration must
be given to service clearances and the weight of
the cylinder when filled.
CONNECTION DIAMETERS
DOMESTIC SIDE
Cold water inlet and hot water
draw-off 3/4” female.
PRIMARY SIDE
Coil flow and return - 3/4” female
SAFETY VALVES
Temperature and pressure relief - Inlet
group 15mm x 15mm pressure
relief - 15mm
TUNDISH
15mm x 22mm compression
SECONDARY RETURN
Standard on cylinders 200L and above